PIONEER METAL FINISHING, LLC
2nd Shift Line Operator - EN (Finance)
Responsible for having the loads inspected prior to picking them up for identification, tooling, security, heights, and depth location.
Coordinates all loads with Team Lead/Shift Supervisor to utilize all open tank time efficiently.
Responsible for making sure there is a program prior to processing loads. If not, contact Team Lead/Supervisor immediately.
Process special loads as assigned using precise specifications and proper communication between process techs, supervisors, leads and other line operators.
Ability to run multiple lines in facilities where that is applicable.
Strives to produce consistency from load to load and shift to shift by means of communication and teamwork.
Makes sure product is processed to program and acceptable to your best judgment.
Identifies and escalates issues with product in the raw state. Notify the supervisor of problems such as: excessive oil, deep and blind holes, areas that may air pocket, corrosion, galvanic, etc. In addition, must be able to recommend process adjustments to meet end product specifications.
Participates in tank maintenance activities.
Rejects any loads that do not meet standard processing requirements.
Monitors pH and solution levels in all tanks that require it. Monitor tanks and make adds as required by daily checklists and procedures. Advise lab if non-conforming tanks are found. Change tank filters when required.
Displays good communication and ability to interact effectively with others.
Responds to alarms and follows applicable protocol. Monitor proper functioning of waste treatment system if applicable.
Understands how to operate standard equipment such as rectifiers, pumps and cranes. Understands set up calibrations and basic trouble shooting for equipment including data tracks and controllers.
Responsible for documenting and maintaining accurate information on run sheets such as correct temperature, loads, voltages, etc.
Provides proper shift handoff and strive to maintain consistency between shifts.
Keeps all work areas and equipment clean, safe and orderly.
Responsible for cleaning the contact pads on the work bars and tanks to ensure full electrical contact through the loads.
Responsible for immediately reporting any equipment problems to via designated procedure.
Escalates any issues or ideas for tooling improvement via facility protocol.
Work Environment/Physical/Environmental
· Repetitive lifting up to 50 lbs. unassisted
Must be able to walk/stand 60% of the day
Sharp parts, sharp tooling, heavy carts, occasional hot and cold temperature and humidity levels, heat from ovens, moderate noise levels, limited hand and air tool use, compressed air (must use hearing protection.)
Must be able to differentiate between color variance
Responsibilities are repetitive in nature
Various chemicals used in the process
Education/Qualifications
· High-school diploma or equivalent preferred but not required
· Proficient computer skills
· Ability to navigate Dynamics and perform production duties using Dynamics
· Ability to follow procedures to perform job duties (ex:) Ordering raw parts, Tooling request, Calibrate eddy current tester, Process verification and applicable testing.
· Strong oral and written communication skills